隨著物流行業的發展，叉車也走上了舞臺，但是在叉車的使用上，我們應該注意正確的叉車用水，這珠海叉車出租小編跟大家介紹一下正確的叉車用水到底是怎么做的。
with the development of the logistics industry, forklift trucks have also stepped onto the stage, but in the use of forklift trucks, we should pay attention to the right water for forklift trucks. this article introduces how to use the right water for forklift trucks.
如何正確澆灌叉車?
how to water the forklift correctly?
使用較硬的工具慢慢撬開電池上面的蓋子。有的電池蓋是abs膠，有的電池是連接到扣上的。有滑板。注意撬開蓋板，不要損壞蓋板。
use a hard tool to slowly pry the cover off the battery. some battery covers are abs glue, and some batteries are connected to the buckle. there are skateboards. take care not to damage the cover plate.
六個排氣閥的橡膠蓋清晰可見。打開橡膠蓋，露出通風口，從通風口可以看到電池內部。有些電池的排氣閥底座可以擰開。排氣閥底座無需打開橡膠排氣閥即可擰開。一些電池的橡皮帽周圍還有填充物。
the rubber covers of the six exhaust valves are clearly visible. open the rubber cover to expose the vent, from which you can see the inside of the battery. some batteries have a vent valve base that can be unscrewed. the exhaust valve base can be unscrewed without opening the rubber exhaust valve. some batteries have padding around the rubber caps.
打開蓋子，看孔內是否有干燥現象及水的位置，即電池是否缺水。電池板用白色玻璃纖維棉覆蓋，通常應保持濕潤。用滴管吸入蒸餾水，通過排氣口注入電池。用透氣罩蓋住排氣口，防止灰塵落入排氣口。
open the cover to see if there is any drying phenomenon and water position in the hole, that is, whether the battery is short of water. the panels are covered with white fiberglass wool and should generally be kept moist. the distilled water is sucked in with a burette and injected into the battery through the exhaust port. cover the exhaust port with a ventilation hood to prevent dust from falling into the exhaust port.
建議使用二次蒸餾水。補水的原則是少喝總比多喝好?？商砑恿坎粔?，酸比重下降太多，電池容量就會不足。如果你沒有經驗，你可以使用玻璃，塑料和其他吸管每孔。建議使用一次性醫用注射器，使用方便，測量方便。補水工具不應使用任何含有金屬的器皿，注射器應從金屬針上取下，使用后設置塑料管。
secondary distilled water is recommended. the principle of replenishing water is that drinking less is better than drinking more. the capacity of the battery will be insufficient if the amount of additive is not enough and the proportion of acid drops too much. if you have no experience, you can use glass, plastic and other straws per hole. it is suggested to use disposable medical syringe, which is convenient for use and measurement. the water replenishing tool shall not use any utensils containing metal. the syringe shall be removed from the metal needle, and plastic pipe shall be set after use.